Bonbo 10Pcs Flanged Ball Bearings 1/2" x 1-1/8" x 1/2" for Lawn Mower, Wheelbarrows, Carts & Hand Trucks Wheel Hub, Double Seal Deep Groove Ball Bearings

These are machined bearings that have been lubricated. The outer race is precision where the original bearings appeared to be stamped. When assembled into the mower wheels the wobble was gone, and the lawn machine rolled effortlessly. I recommend these.I used caution when tightening the wheel nut not to over preload the bearing, only tightening to the point that any looseness on the wheel shaft was eliminated. I expect overtighten could exceed the preload capability of the bearings.

Great quality for the money.

Got this set for my 2015 Kobalt 80V Electric Mower rear wheels. No wobble now. Hopefully they'll last a few years. My mower is still kicking after 7 years in this TX heat. Still using the 2 original batteries but the wheel bearings have been shot for a couple of years. Heavy use. These bearings fit great and with a washer or two everything is snug as a bug in a rug. Slava Ukrainiy!

Bonbo 10Pcs Flanged Ball Bearings 1/2" x 1-1/8" x 1/2". Wheel bearings for 7021P Husqvarna walk behind mower that was purchased in 2011. When I could not find any information on the original bearings, I used the dimensions to find replacements. The Bonbo bearings are not an exact match but worked fine. A standard 9/16 socket worked on the axle nut and wheels came off easily. Some of the original bearings were tight in the wheel bore and needed to be gently tapped out. The new bearings were also snug in the same bores, but were easily pushed in once lined up. There is a thin thrust washer at the mower end of the axle which was reused. There was a smashed O-ring behind the thrust washer. These were replaced with 5/8 OD X 1/2 ID X 1/16 THICK O-rings. Once all was assembled, the wheels turn freely but the wobble was gone. Note: the instruction sheet that came with the bearings, suggested packing everything with grease. I chose not to because the friction in the bores causes the outside race to turn, and the bearings come sealed with grease inside. Grease or not, your decision. The product appears to be good quality and consistent. I cannot say how they will hold up. I doubt that I will ever push this mower far enough to know.I gave it 4 stars because dimensions need to be stated in thousandths for folks looking for exact size.

These fit my kobalt 80v push mower easy to remove the old bearings and replace with these. Hopefully these will last longer than original ones which was almost 4yrs. But if not at least it’s an easy cheap fix. Just needed for rear wheels takes 2 per wheel so there’s enough to do all 4 wheels and have 2 extra.

These bearings do the job I needed them to do: replace the bearing in my lawn mower wheels. Thankfully they come in the quantity they do since I needed more than I thought and this package had enough!

My self propelled lawnmower Husqvarna hu700h had a problems witht he wobbly wheels.This set of ball bearings solved all of my issues. I installed two on each wheel and now enjoying the smooth ride.

size is correct some come a bit smaller but this exactly the correct size

The order came in a timely manner, I replaced the old bearings with these one & the lawn more wheels so much freely now. Excellent

Très bien fait, roule mieux que l'original.

Replaced wheel bearings on a Lawnmower

The bearings seem to be well made with substantial material. They roll smoothly.