Motorcycle Handlebar Control Switch 1'' Handlebar Switch Kit with Wiring Harness for Harley Dyna Softail XL883 Black ESUBOSHI

I was blown away they came with a wiring diagram

This product is well built however doesnt fit any motorcycle and has no wiring diagram located anywhere on the internet. This product doesnt fit any OEM Harley Davidson motorcycle and there are far to many wires in the left handlebar control then any Harley motorcycle model has.

They fit but the wiring is jacked up the wiring diagram they send you tell you nothing be prepared to rewire the ends don’t fit stock harness

Product wasn't right. Plugs didn't match. Gonna go to the manufacturer

Be prepared to do a lot of researching with very little results to get these wired properly for a Sportster. Wiring instructions are a joke! None of the wires match up to factory, has spade terminals instead of round so you will have to unpin them and change the ends out to fit in your stock connections, and extra wires you will have to splice and/or remove completely (if you don’t have a clutch switch)! On the left side you have 2 wires for a clutch switch, the right side you will have a green wire outside of the connection that you will have to splice into the red/white wire before the pin end.

Took a little extra fabrication to get them to fit but once I got them on they work great

Product damaged at their assembly plant it’s unusable as shippedIt took a while for my project to get to the wiring stage where I discovered this product was defectiveIt’s after 90 days, ZERO Support from this company

Absolute junk! First they don’t fit handlebar without filing. Then once you finally get them to fit and try attaching grips the throttle doesn’t move. Wire harness doesn’t fit Harley so I cut it first off or I would be returning.Complete GARAGE!