Spyder Auto 5001542 Chevy Suburban/Tahoe 1500/2500 00-06 / GMC Yukon/Yukon XL 00-06 / GMC Yukon Denali/Denali XL 01-06 (Lift Gate Style Only) LED Tail Lights - Red Clear

I like the way they look and they work well. The brake light and parking light were fine for me. I would buy these again. Plus, I used some LED bulbs for the back up light that make it look like headlights when I back up.

Great upgrade for a 2003 Yukon XL. It gives a clean updated look. None car enthusiast think that your old Yukon is the latest model...It is true that the wires are too short on the passenger side. Actually, the car wires are too short because of the order of plugging them gets changed. You have 3 wires to plug: backup light, turning light and brake like. This housing changes the order, and consequently, one is too short. Spyder should provide a small pre-made extension to keep things just plug & play and professional. For right now, I just did not secure the top plug in order to have enough cable length to put the housing back. I looked at buying the supplies needed but it will cost me around $30. I don't have any wires, with the proper color code and gauge, from an old project, and would have to buy more than needed. For right now, I am planning to secure things with electric tape: secure the electric contact area and close the top hole where the light is supposed to be located. I hate doing as it won't look professional but it will be as safe and it will protect things as it needs to be.I did replace the stock backup bulb with LED ones (Spyder tells you to re-use the old one, but it goes against the goal of saving the battery and having an updated look). I used, JDM ASTAR Extremely Bright 3030 Chipsets 3056 3156 3057 3157 4157 LED Bulbs with Projector, Xenon White. They do fit and do work very well: fitting, color is bright white and the lighting pattern is perfect. They are very powerful: 1,500 lumens. I am in a remote / mountain area where it is great having that level of lighting when backing the vehicle or when approaching the vehicle (perimeter lighting). However, if you are in an urban area, I would suggest a few less lumens.By the way, I don't have any issue with hyper blinking and error messages. I do I have the stock OEM blinker module and everything in my Yukon is pretty much OEM. So far, i have updated the inside lights with LED ones, installed a front Auto Ventshade 25912 Bugflector II Hood Shield, a Pioneer AVIC-X7200NEX with front and back cameras and a Digital Guard Dawg with remote start. Future projects are fog lights and headlights. After that I would like to install the blind spot monitoring system and a rain sensor system.

I installed these on my 2001 Chevrolet Tahoe LS. I got the Black Smoke style taillights.I recently converted all of my interior and exterior (minus headlights and bumper lights) lights to LED, so the next step was to replace the tail lights. YOU WILL NOT REGRET GETTING THESE LIGHTS. The smoked lens are perfectly done. Just enough to give that smoked look without compromising performance and functionality. The red LEDs throw light much farther and better than the stock taillights. I personally like the black and smoke, it doesn't give that "ricer" look at all. It looks amazing and I've been getting compliments with them ever since installing them. These are literally just plug and play, and work near flawlessly. Below are the flaws/things to keep in mind I have seen so far, though they are extremely minor:THINGS TO KEEP IN MIND:-These are aftermarket taillights, and thus do not fit as well where the stock taillights went. There is a slightly bigger gap now, but I have driven in snow, fog and heavy rain (even went through some serious mud) with these on and I haven't noticed this being an issue.-The wiring for the passenger side reverse light is a bit short, but you can still make it work. It will be a tight pull, personally I just cut some of the plastic tubing that hold the wires together to allow for a little more room.-These do not come with an LED Reverse Light! They use the stock reverse lights! I highly, HIGHLY suggest replacing your stock reverse light with an LED one. You can go to Walmart and pick up a pair for fairly cheap that work incredibly well. You can see so much better with the LED reverse light as well. For my truck, it used a 3157 LED White. It's plug and play with the light as well.-You need to use the metal clips from your stock taillights! The screw goes into these metal clips. You won't be able to secure them without it. I used a screwdriver to inch the clips off my stock fixtures and onto these new ones. You can go to an automotive store and they will likely carry the clips. You can choose to go with either option.Because they are all minor flaws, I can't justify knocking off a star. The performance and look makes up for it.

I damage my left taillight beyond repair. It would not pass inspection on august when I install new taillight The new taillights are broken keep blowing Fues. Request replacement I didn't know the return policy had run out earlier just open the box to install today.

First, the likes:-Simple enough to install. LED's are plug and play, and you get to pick whatever backup light you want.-Plastic seems decent. Not as robust as GM's, but it looks nice.-They come in a variety of colour configurations to suit your style (clear, red or smoke lens with chrome or black backing). Mine is the smoke lens with chrome backing and it looks nice.-Packaged quite well.Finally, the small dislikes that I have to knock a star off for:-As people have mentioned before, these do not come with the metal tabs that the screws screw into to hold it in place. You have to take them off of your old tail lights or buy extra ones.-The backup light is moved from the middle to the bottom, so you have to pull back the wiring tape and loom in order to have enough wire to reach.-There seems to be a lot of gap between the inner shell and outer lens, allowing for moisture to get inside, which ruins the look of light fixtures for me.I can't really gripe about the price. They are fairly priced. I am interested to see how well they hold up over time.

Excellent product! Literally plug and play! Does NOT give that annoying hyperblink that el-cheapo led turn signals give.Very well built, beautiful finish (made my rear look sexy again). Almost looks like a new truck.The only complaint is that it does not include the clips to screw into, but it's not a big issue since you can just re-use the ones from the tail lights you removed.I didn't read the instructions, maybe they mention the need to that... To me it was a surprise, but that's because I did not read.

Great value, easy install, look great. Awesome upgrade