Full description not available
T**B
One wire, loads of spark and a pretty cool look
Put this in a Ford 400. Trying to clean up the inner fenders and engine wiring. This is a good option for sure. The only thing I will have to keep an eye on is when the hold down is loose so I can adjust timing the whole top of the dizzy wobbles around. Like it's doing the hula. It stops when the hold down is tightened so it's probably just side to side clearance in the hole itself. Install took 45 minutes and I've never heard this engine run as good as it does now.Also something to think about is air cleaner clearance and if you are running the factory motorcraft 2 bbl, the screw in filter is just short enough the get the fuel hose on but long enough to put a little kink in itas it hits the cap and the area where the electrical plug sticks out. I already had 2 fuel filters before that so I bought a 3/8" nipple fitting and all is good. This should not be a problem if you have a 4bbl though. My 14" air cleaner also clears.
L**S
Go for it, it’s well worth the cost!
I was hesitant to buy this distributor.. not only because it makes my ford look like a GM Frankenstein, but because everybody was complaining about it not fitting, and not working... well, read on.I installed this in an all original 1979 Ford F-150 with a 351M. I had a problem with the original not running after changing a few parts in the OEM distributor.It was relatively easy to install, although I had a few minutes with an Allen wrench and lining up the oil pump before it would drop in - but that wasn’t anybody’s fault.The distributor is great. I got it in, fired it up and timed it without vacuum. ThenPlugged in th vacuum line and everything worked great. I recommend this distributor, it’s affordable, and complete.
E**N
Good addition
Seems to be a great idea. A little slow getting here but seems to be worth the wait
A**R
I don't know
Ordered the wrong part by time I had someone to put it in its to late to send it back so I really can't tell you
M**N
Well packed
Professionallh well packed and it really works.We just re-purchased this again because we reallu liked it
J**.
Was pretty expensive to get a rough distributor cap.
The cap had some pretty rough edges under the electric harness plug in
R**Z
Get product fired right up
I had a little more trouble installing this type of distributor than the original type but once I got it in it fired right up. It only uses one wire which eliminated about 10 wires from ignition module and coil. Once it was in, the truck fired up and idled really nice. Defiantly worth it. I hope it lasts!
J**H
good deal
good deal
N**K
Good stock replacement
Used this distributer on my 1955 Ford pickup rat rod with 429cu.in. has aftermarket aluminum intake so size and height became issue. Found thermostat housing from old ford to fit. All good now. runs awesome.
G**G
Hope it works will let you know.
I’m doing the conversion from EFI on a Ford 460 . I need to change distributors so hope this one will work. I’ve been told it does Time will tell. Thanks for the quick service
Trustpilot
1 month ago
2 months ago