Xprite 7" LED Round Headlights Compatible with 1997-2018 Jeep Wrangler JK JKU LJ CJ TJ Hummer H1 H2, Halo Ring Headlamps DOT Approved, High/Low Sealed Beam, Plug & Play, Black

I bought these as a gift for my husband it’s for a 2014 jeep wrangler he put them both on in less then 15 minutes , very easy to install. Plug and play. They are very bright so far so good I hope they last

These are really bright! Works much better than expected!

EXCELLENT ! So happy with these lights, had to leave a review. I searched through so many options before buying/replacing my Jeep headlights, and these by far are the best ! Super bright, perfect range of beam light, and they look amazing when installed, if your looking for lights, these are the ones.

Amazing headlights! Bright yet aim outward appropriately, makes a huge difference in my daily commute.. I did see in a couple reviews some other TJ owners were having issues aligning the drivers side. You need to chip away, about half way up, one of the bucket mounting bolts (the upper right one, facing the Jeep.) hope that helps. But overall very, very happy with these lights.

I finally did it; I fixed my dim stock H2 headlights. These lights are bright and awesome. To install, you need to remove the grill to get to the headlight assemblies. They state these lights fit the H2, this is not 100% true. They can say this only because the lights have the proper notching to lock into the headlight assembly - this is important feature as other lights on the market may not have the proper notching and will not work for the H2. With that said, these lights are not a plug and play fit for the H2 (no LED headlights are) you will have to cut out, with a rotary tool, a good portion of the back of the light assembly to make these fit. Important, do NOT remove the plastic from the assembly, just hold it in your hand and cut it out, or you will spend a lifetime trying to adjust your headlights for driving. Also, the kit does not come with the proper connector for the Hummer, for not telling us this it loses 3/4 of a star. You will need to buy two 9007 Male to H4 Female Extension Conversion Headlight Harness Adapters (see photo).The item loses a 1/4 star due to lack of DRL wiring instructions. To have a true DRL function, I ran the yellow wire down to the lower bumper and tap into the DRL lights wire harnesses (Blue Wires on 2005 H2), instead of tapping into the brown parking light wire adjacent to the headlights, which will turn the halos into parking lights. I wanted my headlights' DRL feature to work in unison with my lower DRLs, not to only turn on with the parking lights. To do this, run the yellow wires down to the DRLs wire harness by the lower bumper lights. Ther are only 2 wires at each harness. Tap into the Blue wires, the Black wires are the ground. Note, the led halo DRLs are dimmer than I expected especially compared to my LED DRLs on my bumper.Over all, these are a great upgrade that are easy to install. The hardest part of the project is taking of the lower and upper grills without breaking the tabs - there are You Tube videos for this.The only problem that I have is since installing the lights, stared getting alerts for "tighten fuel cap". I installed a new fuel cap, but the alert still triggers one time after within 5 min of staring the vehicle. Maybe coincidence, maybe not.

I bought these for my 2010 Wrangler. They are easy to install but I did grind on the plastic bucket on the Jeep a little to ease installation. It was easy to see where I needed to trim and won't make any difference to strength ot the ability to return to stock headlights. There's a tab on the headlights that's slightly larger than the slot in the bucket.No unexpected issues installing on my Jeep. I hooked the halo wire to the turn signal wire just under the headlights - the halos come on when I start the Jeep and when I use a turn signal, that side halo flashes, which I really like.They look a lot like the newer JL headlights. Great, sharp cutoff line, plenty of low beam and incredible high beam output.

I was hesitant to buy the cheaper priced lights and was looking at the $500 ones thinking they would be more reliable but I've had these for about a year now with absolutely no issues. I'm really happy with them and they look good even when the lights are turned off

Just like so many others, the headlights are too big to fit into the base housing. How do you mess up this measurement? I screwed the bezels on anyway. Well see if they stay in and not move. The adapter connectors do not fit well with the car's connectors. It took alot of forcing to get the connectors to snap in. Not sure how they will hold up. If you want the day time running lights feature to work you must run a single wire per bulb to the fuse box. Thought they were plug and play, ah NO.