mxuteuk5pcs 110V/120V Mini Rocker Switch Illuminated Snap-in DPST Toggle Power ON-Off Switch 4 Pin Red Light, Use for Household Appliances Industrial Equipment MXU1-4-201NR

This part worked great replacing my Bad switch on wet/dry vac. Will see how long it lasts??

Used these to replace the power switch on a Fender Mustang II guitar amplifier. The built-in LED is nice.

This switch was the exact size, of a failed switch on expensive medical equipmemt. Appears of better quality of original switch. And if it fails again I will have four more switches at a very reasonable cost.

Do not expect Mil Spec part as it is a low cost import but good value for the money.

I had a faulty power switch on one of my bass amps, so I ordered these to replace it. Although the original switch was not illuminated, I was hoping I could get illumination with this, but I admit that I did essentially no research aside from making sure I was ordering the right physical size of switch. Replacement was easy (insert disclaimer about working with 120V power and/or large capacitors in power supplies). As it turned out, while I could get the switch to function OR illuminate depending on where I connected the two leads present in my amp, I had to settle for making it work. I suspect that I could add a lead to ground to get the light working, but I haven't bothered to figure that out yet. The important thing is that I can practice in my office again! Switch has a good solid click and should be hard to accidentally turn on or off.

The power switch in a brand new 30A power supply listed on Amazon proved to be defective, and I seen reviews where others were having the same issue. This was a direct replacement with the same ratings as the original, but this one works and has a much more solid click when switched. I'm very pleased and no longer have to switch the supply on several times to get it to come up.

4 of the 5 switches already failed (in less than a year). I'm on my last one, but I will buy a genuine part replacement when this last one fails. These switches are rated for 10 amps at 125 vac. The shop vac draws 9.9 amps at 125 vac. It should work without burning out, but I think the switches are overrated. buyer beware!

This was a perfect replacement for the switch used in my PA speaker. Nice that this little part save me replacing $1000 speaker. Good job!

Shop Vac couldn't sell me a replacement switch for my 15 year old shop vac. No one had it as a part but I noticed on the old switch it said T125. I Googled that and even though on Amazon it didn't actully say T125 it looked the same and the specs were the same. Poped it in and away went my old vac. Very very happy. It says an 8 pack but its a 5 pack, no big deal as one fixed my vac.

Great fit for my amp.

Easy to install

Bought these as I needed a new switch for my wall heater (110v). Works as it should.

I fixed my heat lamp replace the power switch and it fits completely