LG 18,000 BTU Window Air Conditioner, 230/208V, Cools 1,000 Sq.Ft. (25' x 40' Room Size), Quiet Operation, Electronic Control with Remote, 3 Cooling & Fan Speeds, Auto Restart, White

IMPORTANT: After you receive your AC unit, or ANY refrigeration appliance, it is really mandatory to let the unit sit-UPRIGHT, for at least 6-8 hours, preferably overnight, to permit the Freon and oil in the system to settle “down” in the unit BEFORE you turn it on…. During shipping you do NOT know if the unit was transported on its side, or even upside down, otherwise, you WILL risk damaging the compressor….My first purchase of the LG LW6017R 6000 BTU unit was in June of 2000 which replaced a 17 YO Kelvinator 5000 BTU unit. I installed this in my kitchen window primarily to use as backup air conditioning when a Florida hurricane takes out the power. The 6000 BTU size is easily powered by my iGEN2500 inverter generator which also keeps the refrigerator, (beer), cold when the power dies. Recently, my home central AC died and since my air handler is in the attic – builder’s dumb design – I did not want to put good money after bad and spend THOUSANDS with replacing the AC system with the air handler in the attic. I just bought and installed two additional 6000 BTU units; one in my bedroom and the other in the living room. My bedroom window opening was 46 inches wide and the supplied “accordion” side panels would not extend wide enough to block the sides of the AC unit. For the living room window, I “could” have used the accordion panels, but, I wanted to make the installation more “permanent” and I cut pieces of wood for the side panels for both the bedroom and living room installs with pictures showing the final installation. As the units have a cheap, plastic air filter, I also added cut pieces of the white/blue filter material, WHITE SIDE OUT - air input, (ASIN B0DHNBGSXV), and with using the hook side of adhesive Velcro strips, I was able to use this white/blue filter material to ensure a proper air filtration that will keep the evaporator coils clean. See pix. The bedroom and kitchen units provide COLD air with the units cycling during the day. The thermocouple meter shows a 45.1 degree output air temp with a 28.1 degree temperature differential, which is GREAT. The living room unit cools a larger area and with recent 97 degree Florida HEAT, this unit’s compressor runs most of the day. In 95-97 degree heat, my three day electric cost @ $0.14/KWH, for ALL THREE UNITS, was only ~$6.00 or about $2.00 per day, (BR=$0.42/DAY, KIT=$0.45/DAY, and LR=$1.13/DAY)…. You can’t beat that with a stick ;-) As air conditioning is really mandatory in Florida, I am happy as a cool clam without breaking the bank. The remotes are IR which lets you remotely adjust settings individually where an RF remote would definitely cause problems in adjusting an individual unit’s settings. Overall, with the features and performance of these LG units, I can totally recommend these units for keeping your cool for minimal cost….

Ive been working on a project turning my 1950s aristocrat camper into a modern smart home. This is the smallest window AC I could find online and so far I love this lil guy!! LG is pretty legit. I was able to install it in the utility door on my classic Aristocrat camper on a slide out tray. I was limited by the size of my utility door so I had to do some adjustments but its perfect now. I also have an ecoflow battery and solar setup so no matter where Im parked I am finally able after all these years to run a "real" ac unit. If no solar then I have the car battery amp that will charge the camper battery in 2hrs. This new battery tech is amazing!! Just finished my sun shade too and wow now my lil ac unit isnt working nearly as hard to cool things down. FYI Ive gone to the Utah desert in summer and in direct sunlight mid afternoon with no sun cover the ac would keep my 200sq camper space at the low/mid 90s. If Im shaded it will knock it down 20 degrees. For reference the camper isnt insulated at all kinda a bummer but if I didnt have anything cooling it down it has gone above 140! Its a perfect lil oven. Everything melts at that point. Not having a good time. lol If you know you know.. this is a game changer for me! and I also got 4 small 4watt clip fans and they have really helped move the cold air around. All I need now is a starlink to check in with loved ones and maybe some netflix... PARADISE!

I bought 3 of the LG 8000s total, as well as two very expensive Friedrich Kuhl heat pumps to replace a large Lennox Central Heat Pump that failed after 25 years of service... so here is a very long winded review, covering all three of those pretty much. I'll put the info about the LG first for those of you who want only the bare bones of the story, then follow up with the entire documentary. :)FIRST POINT:The LG units are easy to install, even though they do REQUIRE an outside support, bought or made.They are inexpensive to buy at certain times of the year, but my Friedrich units EACH cost 5 times as much or more! I am much happier with the LG than the expensive Friedrich so far, even though I have to use space heaters in those rooms in wintertime. My only regret is that I did not get LG units that included a heat panel to help heat the larger rooms. I am considering when the Friedrich units bite the dust, replacing them with 10K 230V LG units with heat panels for the larger rooms. The 115V heat panels can't heat any better than a cheap space heater and at 230V you can heat twice the area.MORE EFFICENT AND LESS ENVIRONMENTAL CONCERN:Uses R-32 coolant which I understand to be less threatening and more efficient. Additionally it has a rotary compressor which is quieter and and more economical to operate. Various coolants get different opinions expressed depending on what article you read, so I can't verify this information.LESS NOISE:The LG is quieter overall. The big Friedrichs do have quiet fans on LOW and will blow so hard on HIGH that you will think you have a commercial pedestal fan blowing on you. But the Friedrich compressors are LOUD and make strange sounds sometimes... even in the middle of the night they rattle and shut down with a shocking clunk sometimes, and occasionally make a noise like someone sneezing loudly and a scary HISS when the compressor cuts off. The LG just comes on and goes off, no big deal. I don't know much about the rotary compressor, but you can't even hear it go on and off unless you have the fan on low speed. I'm sure that if you went to the same trouble I did to mount it in a window or through the wall, it would be almost as quiet as a mini-split unit.COOLS WELL, EFFICIENTLY:Measuring my LG in comparison to my 10,000 BTU 115V smaller Friedrich, it burns half the electricity to cool the same area. I know because I had to use one of the LG units in there for a month while I was battling Friedrich service centers to fix that unit. I measured their power usage under multiple conditions with my Kill-A-Watt power tester. Yes the LG does come on a little more often to do the job, but still burns less power in a week overall.LG IS NOT AS HEAVY DUTY:But it is also not as heavy in weight... much easier to put in and take out. Some of the knobs and switches and deflectors are a little flimsy, but if you treat them with respect, you shouldn't have problems... time will confirm that, I'm sure. But the one major point here is that the chassis is not as strong and without the outside support bracket (or the cheap-skate version in my photo) there have been reports of the chassis warping to allow fans to rub and make a lot of noise. Plan for that and you'll be satisfied.FANS ARE NOT AS POWERFUL:The LG blows about as much in high speed as the Friedrich blows in medium speed. I don't use the high speed in the bedrooms of course, but if you are trying to cool two rooms with a single unit, you might wish you had more powerful blowers.FAR LESS COMPLICATED:The Friedrich Kuhl models have very complex controls, especially on the remote. You can program them to do all sorts of schedules to turn them on and off, but all of that proved silly to me. Easier to just set the LG and forget it. All of the various modes of the Friedrich end up with you dinking around with the controls far more than the LG units. Plus both of my Friedrichs have trouble maintaining the set temperature, not because of capacity, but because the sensors don't work properly and I have to compensate by several degrees, which is even more trouble due to the heating function.WAY LESS EXPENSIVE TO BUY:The Friedrich units were about 5 times the price of the LG units. Do I expect them to last 5 times as long? In a word NO. Also to consider is that the Friedrichs each weigh 110 pounds, and that will kill you when you have to remove it to take it for service.MY DIY SUPPORT:You can buy the LG outside supports and they are not that expensive, or you can use the less attractive DIY system in my photo. Two scraps of fiber cement plank and a length of 2X4 and you can fine-tune the slant of the unit by simply tilting the 2X4 slightly with a level on top of the unit.MY DETAILED STORY:We have had a Lennox central heatpump for the past 25 years which lost it's ability to heat a few years ago and then the cooling function died at the end of last summer. That was a great heat pump, obviously, and though it lasted a very long time, it was not all that efficient due primarily to the big lie that's told by the central system sellers who always fail to mention that you have to cool/heat the whole house in order to make the system work properly. Central systems require the air to flow as designed in EVERY room for the system to work properly, and frankly, not many people need to cool the whole house 24/7.For just two people, unless we have guests, three of our bedrooms are empty every day, entered only very occasionally to clean up or get something. The doors are always closed. Sadly, if you close off the vents in those rooms, it affects the efficiency and longevity of the overall unit.When the Lennox died, I had estimators come and even with the house already having central ducting, the estimates ranged from $6500 to double that, and not one of those guys offered anything near the quality of the Lennox unit.I first thought I'd like to get the modern “mini-split” units, but this turned out not to be practical either from an installation standpoint or for overall cost of installation. The price for that turned out to be more than for a new central system, but each of the estimators declined because some of the rooms had no good place outside to put the compressor. So I started looking at window or through the wall units.But in considering going to window units (or through the wall), there are many points to think about:1. They are more noisy. The compressor is right there with the blowing portion, so you will hear that compressor each time it comes on. Larger units make more noise, and that's just logical.2. Large units are expensive and heavy, and if you need warranty service or repairs later, some service companies will NOT come to your house to even look at them... you'll have to take the unit out and haul it to the repair shop. This could be a good thing or a bad thing... read on please.3. Smaller units are less expensive, lighter, easier to install and replace.4. By installing individual units in each room, you get full control over the temperature in each room, rather than having to cool rooms that are never used. Your guests will have control over their own bedroom, which they will appreciate if they like a warm room and you like a cool room or vice versa. Of course this also means you can turn any of the units off to save electricity.5. Last but a very important point is, when a central a/c system breaks, the whole house is broken. With a window unit, you only have one room in trouble, and you don't have to wait days or weeks to get someone to come and look at it, order parts, then come back to fix it... you just pull it out of the window and take it to the repair shop, or pop in another unit, either new or borrowed from another room. In my experience, having the repairman come to the house multiple times to fix our big Lennox, it would have actually been cheaper to buy a new window unit than the high cost for repairs.So, I did decide to get a mix of window and through the wall units and install them myself. The cost of the units totaled out to about the same as the lowest bid for a central unit UNinstalled, but that brand had so many bad reviews I just couldn't consider buying it. I decided to buy two very high priced Heat Pumps to take care of the areas we use every day and then 3 of these LG 8000 gems to do the seldom used bedrooms. I now wish I'd bought the LG units for the whole house. It would have been cheaper initially and would probably have worked better. I bought Friedrich Kuhl heat pumps at a total cost of about $2500 and installed them myself. They are VERY loud, but also very efficient... but there were problems. Each of them weighed twice as much as the LG units, so it was horrible trying to put them into the places (both required windows to be removed and bolstered to handle the weight, which was too much for the window to support on its own). Plus of course one of them required wiring for 220 volts. One of the Friedrich units did not work properly at first and I had to pull it back out of the wall and haul it 65 miles to get “service” because they “don't allow their boys to take them out of the wall”. So this 76 year old man and his hundred pound wife had to do it for them. I took it to the warranty repair place and had to leave it because they didn't have time to look at it in front of me. I waited nearly a week and called them back and was told there is nothing wrong with the unit (which cooled like a Texas Norther, but did not stop cooling... would freeze you out). I told them I would come and show them the problem, but when I got there, they'd all taken the afternoon off, and the receptionist wanted to CHARGE ME MONEY for testing the “good” unit. In all that brand new unit took a month to get going, many phone calls and emails, trips to two different cities.So no, I will never again buy a central unit OR a big window unit. The little LG 8000 is the perfect a/c because it is light enough for us to lift it and if I have trouble I can't fix, only one room is out of service, and I can actually swap units with another room if important. In fact I can toss the thing in the dump and buy another one cheaper than some of the repairs I've had on big units.CONCLUSION:It almost brings tears to my eyes thinking about my father so many years ago deciding he had to air condition this 100+ year old farm house. He had to have the venting put into the attic, additional wiring installed, and then picked the very best central unit he could find, which involved a large loan to be paid out of his Social Security and small pension... resulting in a lean on the house title. He could have installed window air conditioners with considerably less expense and only used many of the units when there were guests present, as I do. The extra safety factor of having many small units (all the same) is a huge relief, because when one goes down, you just borrow a unit from one of the spare rooms until the broken unit is repaired or replaced.Obviously I fully recommend the LG, but do make sure you buy or make a support for the outside.ABOUT THE PHOTOS: These were taken late last summer (2016) while I had it installed in the livingroom for a month. It was pretty much just stuck in that window while the big Friedrich was having warranty issues.

great service fast shipping ac works great !!!