39.3 inch Carrier Drag Chain Cable Wire R18 10x15mm (Inn H x W) Plastic Black Open Type for CNC Router Mill and 3D Printer,Wire Carrier Cable with 1 Pair Connectors,1pc Screwdriver,12 Screws

I have a 20 watt X-Tool D1 and it works great but the cable management, not so much! I mounted this cable chain on the side of it and routed all the cables through it and it works great! Completely solved the problem with the X-Tool's cable management issues.

I used on my CR-10S 3d printer for a drag chain for the bed. Before I had an old 3d printed chain and it always sagged because it was rotated 90 degrees. This one is so much better and is solid without any sag.

Used this to finish the cabling on my cnc router. Worked great!

Ended up not using it for my project, but the build and quality looked very good im impressed.

Used this on a robot - was strong (some others can tend to break or come apart, which this one did not) easy to add to pre-run cable due to the tabs.

Perfect for what I needed it for

This little energy chain is exactly as described, worked perfectly, included hardware and extra mounting brackets. The chain covers open and close easily and the chain works perfectly. Highly recommended.

I bought three, two of the same and a smaller one for my CNC router I'm building. Unlike cheaper versions, these lay flat, fitting the application just right with no risk of sliding off sideways.

Fast shipping