67Inch Collapsible Threshold Water Dam 1.5" high Walkin Shower Guard To Keep Water In Shower Stall Water Barrier Silicone For Dry And Wet Bathroom Wheelchair Accessible 5.6ft
Item Weight | 1.74 pounds |
Package Dimensions | 10.79 x 10.71 x 2.13 inches |
Size | 1 Count (Pack of 1) |
Color | 1.5" High/White |
Style | 67inch |
Material | Silicone |
Batteries Included? | No |
Batteries Required? | No |
J**N
Works great
I had removed the metal/glass enclosure on an RV shower and replaced with a collapsible rod and curtain. This product was used to form an elevated edge along the bottom front of the shower. I bought large enough to cut down to size and fitted it carefully. I laid out the piece and then drew a pencll line to help me place it straight. I definitely recommend sizing and fitting it all up before any attempt to put it in place permanently.The product comes with an adhesive backing that might have been sufficient as this will not really be subject to much contact, but to be safe I did add a bead of Flex Seal along the bottom and pressed the cut piece down on to it firmly. I also made 3 small horizontal slits (abut a 1/2") on the inside back of the piece using a razor knife, that I could place a screw and small washer into and screw it down into the shower enclosure material, to add some additional stability. (the interior of the product is hollow) I placed a small amount of flex seal in that slit and let it all cure over night and then added some clear caulking along the inside of the ends where it contacts the outer shower wall. The slits are now invisible and sealed closed and the ends are too.Net result - it's held in place well and really did the job. Again, it will not get a lot of serious regular contact, like rolling a wheel chair over it, etc. With a reasonable amount of care it seems like it will hold up well and do it's intended job for regular shower use.
N**B
Does the job
The adhesive strip is not effective. I had to use addition double back tape and apply silicone caulk on both inside and outside of walk in shower. I followed floor prep directions and determined the tape was not sticky enough to provide water tight seal.
T**R
Prep work and finishing makes the difference on this when applying to a tile surface.
Prep work and finishing makes the difference on this when applying to a tile surface.The item was packaged in a tight coil and straightening it makes install easier. The pictures show people stepping on this like it is a soft foamy material. It is stiffer and gives a little when you step on it, but it isn’t comfortable . Basically, it is the kind of material that is forgiving if you step on it by accident every once in a while, but I would not make a habit of it or try to roll a wheel chair over it.The first time I installed this, I slapped it down as quick as I could without any prep work. I could not get it straight cause it was holding the coiled shape. It also leaked under the peel and stick seal because of the uneven tile and grout floor. I still liked the general quality of the material so I ordered it again when I had more time to redo it. The peal and stick did not leave any damage to the grout when I removed it.2nd install, we removed it from the package and coiled it the other direction overnight so it would straighten out. Then, we used Clear Lexel to seal around the bottom and side edges rather than relying only on the peel and stick bottom. After applying Lexel, it does not leak anymore. The install is stiffer now, so it does not give as much if you were to accidentally step on it.
L**Y
Works well
I bought this for my walk in shower. The bottom didn’t come up high enough to keep my shower curtain liner inside so I ended up with water all over the floor. This was very easy to install and has worked well with keeping my liner in and the water out. I did caulk the bottom edges to the bottom of the shower to reinforce it. So far, no issues other than getting used to it and tripping over it a few times. Lol I would purchase again and do recommend it. Only thing I’ll say is make sure you have your measurements right before you cut it. I had to do some patchwork, but it worked out!
J**R
Just like described
We were having issues with water coming out of the shower so we placed this along the bottom and sides of the shower. It was really easy to install and works great!
N**S
Great Product!
Easy to cut to size (use a fresh blade in a box cutter style knife for a super clean cut). Good quality.Note: If you're living in an apartment with a walk in shower that's splashing everywhere, but don't want to lose part of your deposit for permantly installing this, you can use DAP Peel and Seal caulk instead of traditional caulk for installation so it's easy to remove when you move out :)
B**B
Works
Good adhesive
T**C
The adhesive isn't strong at all. Bending the top makes the bottom open.
The adhesive isn't strong at all. Bending the top makes the bottom open. Only works if you do not touch the thing at all. If you step on it, expect the whole thing to fall.
G**A
Perfecto
Me sirvió Perfecto me gusto
C**A
Buena
Muy práctico pero necesita silicón para evitar completamente el paso del agua
G**
Mala calidad en el pegamento
No duró ni un día, se despegó.
A**O
Muy malo
El pegamento con el que viene, se despega al tercer baño, y es mucho más caro comprar una cinta 3M para cubrir el largo de la goma, no lo compres.
P**.
NO FUNCIONA
No me funcionó. Se despego en dos días que lo puse. No lo regrese porque ya lo use pero no funciona.
Trustpilot
1 week ago
2 weeks ago