GearIT 1/0 Gauge Wire (25ft - Black Translucent) Copper Clad Aluminum CCA - Primary Automotive Wire Power/Ground, Battery Cable, Car Audio Speaker, RV Trailer, Amp, Electrical 0ga AWG 25 Feet

Great quality for a great price can’t complain good thick wire and thick jacket and also flexible at same time would consider buying again no doubt best bang for buck product hands down

I bought this wire for 2 different reasons, I wanted to wire my golf cart 48v battery for backup power at home for a 1500w inverter. That project went very well even with the crimping. I seen a lot of reviews that crimping was a problem but I didn’t have any trouble. The 2 job I haven’t done yet but I’m sure it will go just as easy as this first one. I will be connecting it to a winch that is in the bed of my truck. Good luck.

For the price, this is great stuff but there are a few things you need to understand BEFORE you buy it so you are not disappointed. The negative reviews are not wrong in most cases and there are some caveats:1. This is measured in Gauge (usually refers to metric size), not AWG (refers to current carrying capacity) and should be called out in aught if it were truly AWG. Gauge is a faux measurement IMHO. The "standard" is so loose and so not really a standard that understanding that right away is important. AWG (American Wire Gauge) is a strict standard and you know exactly what you are getting. Go pay twice this price and you'll get true AWG measurements. Don't want to pay twice the price? Then you're going to compromise.2. The individual strands are brittle as mentioned but that doesn't matter. If you're terminating correctly, it makes no difference what so ever. Voltage drop, heating because of amperage or anything like that does not matter if you lose a strand or two. As a cross section of the wire it is just not enough to make a difference.3. Yes the wire is on the stiffer side, that's a good point made by folks here. It's not bad actually, but figure your bends are going to be the size of a coffee can and maybe not quite as tight as the side of a coke can because it's stiff.Bottom line question: Is this 1/0 AWG (gauge?) Absolutely not. In AWG this would be just about 1 AWG on the thin side. It comes out at about 7.28MM which is basically thin 1 AWG (there is some margin of error in my measurements I'm sure). This is probably 1/0 gauge when you can measure "gauge" any way you freakin' want to.For this price, at this size of wire, you aren't going to do much better. Think ahead. This is a great buy for what you get, just get passed the marketing. I could not find wire this thick at this price on Amazon period and this was the best price by a couple bucks.Buy appropriately.I hope this helped!

Priced right and I like the product so far. It is very flexible, and yes I am aware that it is CCA ( copper clad aluminum). For my needs it has work very well. I used it to wire in an inverter for a Jeep project among other things and has been just fine.

Used it to wire my car battery to my house battery in a Van build; The wire is quite flexible, reminding me of a giant Twizzler, especially the red one; I was often tempted to take a bite out of it. The flexible wires make life much easier when dealing with tight bends.

Great product

Good for price

Good wire good flexibility

Sytème de batterie Solaire

Pour filage dans mon VR

Cable is flexible enough to tuck under trim and carpet in the car. Powers my subwoofer enough to dim all the lights on the car.Only gripe is that you have to be very careful when stripping the wire as it is very easy to cut individual strands and lose some wire. Even stripping carefully with a somewhat dull knife manages to cut through the cable.

Aluminium a intérieur

Good value in my opinion. Quite a flexible product seems to be a durable coating on it.