Detroit Axle - Front 4pc Control Arms for 99-04 Jeep Grand Cherokee 1999 2000 2001 2002 2003 2004, 4 Upper & Lower Control Arms Assembly Set Replacement

Great price to keep the front suspension on a grand Cherokee straight

Okay, so "easy to install" is not something that can be written about any kinds of car suspension system parts. However, that being said. These where a direct fit replacement for the OEM ones on my 2000 Jeep Grand Cherokee Laredo 4.0l. Also just to inform anyone who is looking to purchase them. You have to buy the upper control arm bushings for the axle end separately. The ones I found where a direct fit and once I got the old ones out the bew ones went in fairly easy.

Loved that I could buy the whole front set, with the bushings already installed, for about the same price as just buying new bushings alone. They fit great, with one exception. My 2001 4WD Grand Cherokee had a metal clip installed on the drivers side lower arm, that holds the front diff vent tube away from rubbing on the driveshaft. The hole for that clip was not there on the new arms (see pic, that hole was there on both of the original arms). I drilled a new hole and installed the clip. Everything else went quite smoothly. Overall, they seem to be great. I'd like to rate them 4.75, but that's not an option. ;-)It would be near perfect if the kit came with those 2 bushings that are pressed into brackets on the axle housing. Without replacing those, the job is only 75% complete. :-(Be sure that you tighten the bolts to spec, but don't tighten them until the suspension is supporting the full weight of the rig. If you tighten them while the suspension is hanging down, then the bushings will be getting twisted too much when the suspension is compressed, resulting in a greatly shortened lifespan. The lower ones have to be TIGHT, 115 ft/lb for the frame end and 120 ft/lb for the axle end. Tough do do while the rig is sitting on the ground. The upper bolts are much smaller and only have to be torqued to 45 ft/lb each.

Perfect dimensions and fitment.

These match the OEM sizing perfectly, so there were no issues on width or length in installing these. Bushings appear to be good quality. The welds on the upper control arms look sub-par, but they seem to be holding up fine.I also installed two new bushings for the upper control arms at the axle as these are not included. Between those and this kit, all my steering issues have been fixed and it steers great.These were used on a '01 Jeep Grand Cherokee.

Great deal, my control arms were wore out and needed replacing. These fit great and worked great. I saved a bunch of money and the quality seems good too!

They are great they fixed the issue I was having.

Parts fit exactly as they should, much better price than OEM and held up great through a wk long off-road fishing trip! As well as these parts helped me figure out the axle I just bought & put on is bent... Control arms are just how they should be though!