Neoprene Rubber Sheet Roll 1/16" Thick x 12" Wide x 10Ft Long with Adhesive Backing (Including Utility Knife), Heavy Duty Self Rubber Seal Strips Roll for DIY Gaskets, Flooring, Seals

Great product, for so many different types of uses.

I put 5 stars so you would read this. I cut this rubber to line my battery box on the inside. Would not stick so I used the 4 inch wide rubber from Amazon with the red plastic backing thank God I had it. So this stuff is like super glue to the fingers it sticks. The third picture I had to double it in the Lto Lithium box and it's never coming off. So they need to make the 4 inch in 8 inches wide. This junk did not even stick to my sneaker when stepping on it. I ate up the money but it's not Amazon's fault I buy everything from them and it always works.

Pros: This material is thicker than I expected Which is good. The material is tough but it can be cut and trimmed easily with a very sharp razor blade. The adhesive sticks to plastic very well. Cons: This material is stiff, and you must take care and try to flatten it out after unrolling it. Material has a Very strong odor to it. Overall, I would definitely buy this again as needed except I may order it thinner next time.

Perfect, just painted my garage floor and did not want the "hot tire constriction" to pull the paint off the floor, so used this, as well as a "tire guide" you tire bumps into place on, to protect the floor. I used this adhesive back mats, cut to size, to keep the tires off the paint I also used a parking guide that was a windshield target hanging from the ceiling-you aimed at and that when it hit the windshields designated point, your car was in the proper place, and on all 4 mats. I bought the 12' wide, it would have been easier if I had each individual 20" long mats, that i cut off the 12' long roll, were 15" wide, so don't have to be as percise in your parking and having a tire "hang over the mat". If I have to replace one of the mats, i will buy the 24' wide and cut to size, 20" long x 15" wide. So far the adhesive is holding up well,

stick on backing is ok but be careful pealing paper off glue may come off

Good material but the adhesive sucks, mostly use it for padding and grip for the top of my tools chests and what not and if it gets below 50 degrees in the garage the adhesive stops sticking.

Used this to make a gasket on a saleen wing someone had drilled giant holes in the trunk lid to mount and run brake wires through. Worked great no leaks, strong and seems to have held up almost a year or so now...

This product does not meet even the most basic requirement one would expect. It does not stick. I cleaned and prepped. The weather was good. Even so, the adhesive would not hold. The rubber was loose the next day. The rubber itself is fine, but if you are expecting this to stick to another surface using peel and stick, it won’t. Buy something else.