Generator Exhaust Extension Silencer Kit with Insulated Through-Wall Mounting Plate Safely Vent Exhaust Reduce Noise By 52% Compatible With Firman H07552 Wh03242 T07571/3 Honda Eu6500/7000is Muffler

This product worked perfectly for installing a generator in a shed and extending the exhaust through the side. It fit on to my generator with the fittings provided and reduced the noise level.

Generally the quality is good, but the universal adapter did not fit my "KS 8100 iEG" (see pics). So I had to manufacture my own adapter based on Tue one that came with it and drill new holes. Other than that, it seems good. I'll report back after using more if there are problems.Also sharing pictures of a bracket made to hold the pipe centered and connected to the wall.

Well, I submitted a video that was rejected by amazon that addressed these shortcomings. I am a credentialed engineer (retired) and so I give my honest professional opinion of this kit in this updated (written) review.Firstly, RUFUS insists that the hole in the mounting plate is 5 inches when in fact it is 3~3 1/8 inches in diameter. It is shown as such above in one of the photos. If you ask RUFUS it insists that the mounting plate opening is 5 inches in diameter!Why is this an issue? Half of the installations in this country will be in a concrete block, cinder block, or brick wall and in those circumstances there's no need for a 5 inch hole because these materials, in this universe, don't burn.A thermal barrier of 2 inches spacing between the 3 inch mounting plate diameter and a concrete, cinder, or brick wall is completely unnecessary for that reason. They don't catch fire! This should be intuitively obvious.The adapter and the muffler, as shown in the above photos with dimensions, clearly show a disparity in dimension between the hose I.D. and the O.D. of the adapter and muffler. The stainless steel hose, given its hardness, cannot be cinched (mechanically) down over these adapters using the supplied clamps. Another reviewer commented on this fact and I have verified the same. The instructions don't address this issue and one other reviewer above surmised that the foil tape was to be used to make up the difference in I.D. and O.D.'s.The supplier, and I hesitate to say they're the manufacturer of these components, should address this issue. In my professional opinion, using foil tape with an adhesive side to make up the difference between the two is not what would be considered "good practice" and could be unsafe because as the glue on the tape melts, the spacing becomes less and the mechanical connection can slide off due to the melting glue.The muffler and the adapter ends should be swaged to a larger diameter to provide for a safe mechanical connection that isn't going to slide off the end as a result of melting adhesive on the tape. The hot adhesive will actually morph into a lubricant that will cause this disconnect.I made a distinction above between manufacturer and supplier. I don't believe (my speculation) that they're one in the same. I believe these parts are packaged as a kit by the supplier but are not manufactured by them (purchased parts), hence the lack of control over O.D.'s and I.D.s.So, for these reason, I do not recommend this product!

Worked fine for what I need it for. It definitely reduced the noise level

Have not used yet. Would buy again

Good fit ,quiet.

Silencer seems to work well. But< when I tried to tighten down the extension tube I was unable to get it to seal. I wound up going to my neighborhood auto parts store and getting one made of aluminum vice stainless. Other than that worked out great.

I purchased this product for a duromax xp13000eh generator however it is not a simple bolt on. The flange that mounts to the engine is too small.