SAMA 2851A Gaming ATX PC Case, Mid-Tower Computer Case with 4 ARGB PWM Fans, 360mm Radiator Support, Curved Tempered Glass Front and Side Panel - Black

i avoided the argb/fan HUB on the case - its a bit wonky but just went right into the motherboard

The case is great. It has a lot of different choices for light color. Very easy to assemble fans are all set up to the box. All you gotta do is set up your parts.

PC case only has 6 stand offs pre installed in it not enough for a full ATX board unless you like warping it from uneven pressure accessory box is no where to be found so no extra stand offs no screw mounting hardware nothing luckily I have extra but slight inconvenience for those who don't also a random screw falls out the bottom of the box so be careful with that took forever to find but I can't find where it goes so ya but cheap rgb controller that you can't get to but works with to change rgb lightning so ya and they did cable manage and hook up the wires to the rgb controller for you so alittle good with that bad but other then that no complaints solid case tempered glass panels clean slick design if they could at least find a better spot for the rgb controller remember the standoff ls and extras it would be a 5 star easily

This case was easy to use and looks great

All in all for the sale price of 82 bucks you cant go wrong. I wanted more cooling and space so i upgraded from an older MSI mag to this. Using a full ATX mobo 570x unfortunately cant fit fans on bottom due to headers to close to where fan location should be. Definitely not a beginner friendly case. The RGB fan dock was pretty tight for connections had to offset its location to fit everything and the pre wiring/directions pamphlet left much to be desired. Repasted my 5800x3d CPU and now sitting at 29-32 idle and with one fan under my 7800xt my hotspot dropped by a few degrees. The other review complaining about the MOBO offset screws the case had 6 installed and 3 in a plastic bag with other screws so i had no issues mounting. If you're an enthusiast and like a clean RGB fish tank look i'd pull the trigger.

This case only comes with 6 standoffs for the motherboard. It's advertised as an ATX case. ATX motherboards require 9 standoffs to mount properly. You can see in the picture where the missing standoffs should have been. If you have an ATX motherboard, do NOT install it in this case, you can crack your motherboard while inserting the memory and connecting cables. There were a couple different types of screws in the plastic baggie, and a hex to phillips adapter for screwing the standoffs in, but no standoffs.The LED / fan controller board this thing comes with is a rats nest of wires, some of which are extremely short and the cables look ugly the way they are run. You're going to have to pull the wires/fans and redo them yourself.Other than these issues, the case does look pretty decent.