HVAC Blower Motor Resistor AC Blower Control Module - Compatible with 2010-2017 Ford Expedition 2010-2014 Ford F-150 2011-2017 Lincoln Navigator Auto Temp Control - Replace # BL3Z-19E624-A YH-1829

This resistor was for my 2014 Ford F-150 fan motor. I had lost all but one speed. Installation was pretty much a breeze except for the back screw. Some reviewers mention the pins not lining up....mine popped right in with no problem. YouTube videos show you how to install it. However, they do not show installing the back screw. At first, it was extremely frustrating until I finally decided to use a pair of forceps to hold the screw. Dropping the glove box is simple, squeeze the two sides in at the back and it will drop down. I recommend also purchasing the STREBITO Mini Ratchet Set, 22-Piece 1/4 Ratchet Right Angle Screwdriver, 36-Tooth Small Ratcheting Wrench Bit Ratchet For Tight Spaces, $11.99 (Amazon description), and the "SWANLAKE 20PCS Power Nut Driver Set for Impact Drill, 1/4” Hex Head" only $9.99 (Amazon description.) These two tools are invaluable for a multitude of uses. The two screws are 8mm. It was easier for me to remove the front and back screw with the glove box dropped as well as installing the front screw. However, when installing the back screw, I had an easier time with the glove box closed, and lying on the floorboard with a headlight. Using the forceps, I was able to get the screw into the hole and get it started enough to then put the ratchet on it. NOTE: Be sure to replace the electrical tape with fresh tape, putting it on just like the factory did it. If you do not replace the tape, it could come unclipped and fall out....ask me how I know. After installing, I started the truck and had all speeds back up and running. NOTE: Be certain the connectors "click" completely mated. Mine came unplugged after two days and lost all speed. Dropping the glove box, I found it had disconnected. I had failed to press the connection together hard enough for it to click shut.

Replaced on my 2011 F150. Fan speed was stuck on high. Installed and plugged it in. Working as advertised.

I've only had this part on for about a month, so far so good. I was a bit skeptical about getting an electrical component that was not OEM quality. My HVAC system was not working properly on my 2014 F150 and after some research discovered that it was this particular relay. Went to my Ford dealer and they did not have in stock plus they wanted 30% over the cost of this one to order. After reading some of the details from there site i decided to give them a try, part installed and is working perfectly just like the OEM.

Installed mid January it did not last 2 months. Had to replace it again today.

Purchased from Amazon September 2024 and installed upon receipt. Fit and finish of unit were fine. Unit became inoperable January5, 2025, requiring it to be replaced, but with a different brand. This was a very disappointing purchase!

My 2010 F-150 blower motor would only run on high speed even though the speed indicator on the dash showed low speed. Easy fix, just 2 screws to remove and replace behind glove box. This is a 10 minute job and all you need is a 5/16" wrench. The part solved the problem and was 1/3 the price at the local auto store.

I had my teen boys replace this part along with the motor blower, as not sure which part was the issue, and due to the location this part was, in the vehicle, it was easier for them to get to. Install was real easy and fast.

Right part out of the box, it fixed the problem. Just a little awkward to access, 1/4" flex drive with 8mm socket required. 2014 F-150, on the passenger side to the right of the glove box.