HURI Generator Ignition Key Switch + On Off Stop Switch for DuroMax XP4400 XP4400-CA XP4400E XP4400E-CA XP4400EH MX4500E XP6500E XP8500E XP8500E-CA XP10000E & XP10000E-CA

Key fit perfectly with my XP4400EH. I’ll save the other parts in case I ever need them.

Worked perfect and replacing my 3500 gentronics generator that I don't think was ever used on the used camper I bought but fit right in place and turns right over and starts right up

My DuraMax 4400 did not have an electrical plug, and the seller did not provide a pin out to tell me what wires needed to be connected to what, so I was stymied for a time.The key switch activates two circuits: the starter circuit and the shut-off circuit. The starter circuit (switch turned and held clockwise) is between the white and white/black wires of the switch; the cut-off circuit (switch in the off position) is between the blue and green/white (or you can use green and black pairing equally well). On my system I connected the white starter to the already connected together yellow and brown wires, and the white/black starter to the blue wire; the blue cut-off wire was connected to the two already connected black wires and the green/white cut-off wire was connected to the lone remaining black wire. Note there are only active circuits when the key is in either the start or off position, but not in the on position (there are no axillary circuits). With this information it should be fairly straight forward to wire the shut-off switch.In the following list, the first color is that of the switch, the second color is the corresponding Duromax generator wire color. Note, there are no circuits active in run mode, only when the key is in either the shut-off position, or the start position. (There are two shut-off circuits, 1) Blue, Green/white and 2) Green, Black.)Blue , shut-off, black and blackGreen/White, shut-off, blackWhite, start, yellow and brownWhite/Black, start, blueGreen, second shut-off, not usedBlack, second shut-off, not used

Key was what I was after..however even the key doesn't work although it said it would fit my model.

Fast shipping and perfect replacement

Somebody vandalized my Dad's PowerLand PD3G10000E 10KW 16HP Triple Fuel by cutting all the wiring to the ignition. After looking at parts, found that the same switch is used on many different generators and this one matched.They had cut both ends, so I had to put new terminal connectors on the wiring coming from the generator /battery, etc. as well as replace the switch. Pretty straight forward and was able to salvage this awesome generator.

Works fine just. As stated I description I had to rewire/repin connector. Also had to reuse the original connector body from old switche.

Older (2016 ) Duromax xp 100000 eGenerator.